to new vapers, it’s not easy to build your G4 version TF-RTA, now let’s check how to build it.
1.to make sure your hands are clean, so you need to wash them before you do some DIY work.
2. take out your smok G4 deck.
3.install the pre-build coils, insert one end of the coil into the up-side screw, the other end into the down-side screw.
4.positioning and cutting the exceeding ends of wire off, make sure the coils are fixed and lined up with the air hole,
make sure the coil not touching the deck, then cut the exceeding ends of wire off.
5.cutting a strip of cotton and make sure it’s just large than the coil, insert it and place it in the middle.
about the cotton, we recommend Japanese Koh gen do.
6.cutting the wick at an angle and make sure it’s not too short and not too long.
7.wet the coil with e juice and adjust the wick.
warning: before installing the coil, you must to check the resistance and ensure that your device supports it.