+Features:
RBA core for spirals tank, this is single coil RBA, vapers can easily install the pre-made coils on it.
How to build RBA:
- clean you hands
- take RBA deck apart
- install the position the pre-made coil, make sure the coil is fixed in the center
- cut the excess ends of the wire off
- cut a strip of cotton and make sure it's not too much or too little
- insert the cotton and placing it in the middle of the coil
- cut the cotton at an angle and make sure it's not too short or too long.
- wet the coil with e juice, the coils must be checked for resistance before they are fired.
Package:
1*RBA core for spirals tank
Note: please ensure you have basic knowledge on how to properly to use it.
1)if the coils are sub ohm coils, the user should be sure that the tank and mods can handle the sub ohm resistance coils, please make sure you have the great understanding of them, if you are not sure, please do not order and use, welcome contact us any time to get help.
2)Smokstore will not responsible or liable for any injury, damage, defect, permanent or temporary that may be caused by the improper use of Li-ion battery, coils, tanks, mods etc.please have a basic knowledge of batteries.welcome to contact us anytime to get help.
