The Wotofo Profile Mesh RDA, designed by Wotofo and Mrjustright1, 6 fashionable colors available. with wide clamp posts with side securing method allow it supports all kinds of pre-made coils, vapers can switch the mesh or wire coils, to help install the mesh style coil sheet, you can use included bending tool for shaping and fine-tuning the mesh sheet so as to heat evenly. the Profile RDA Mesh with spring-loaded ceramic support at the center of the deck to ensure effective contact between the mesh and the cotton, the deck is accurately designed to work with the beehive style air inlets on the RDA sleeve. the package comes with pre-made Clapton coils and mesh coils, the mesh coil made of kanthal A1 heating material in resistance of 0.18ohm, best performing wattage range from 40W to 60W, equipped with the newly developed mesh style coil, the Wotofo atomizer can function to separate each flavor in your juice, enhancing your experience by layer. the 24MM Profile RDA with side airflow adjustable design, vapers only rotating the top cap to adjust the airflow to your preference. Profile Wotofo supports top refill and bottom feed e juice methods, recommend works with the squonk vape mods.
- Material: Stainless Steel + Peek
- Colors: Black, Blue, Gold, Gun-metal, Rainbow, Stainless Steel
- Size: 32.5*24mm
- Side Airflow Adjustable Design
- Top Refill Or Bottom Feeding E Juice
- 0.18ohm Kanthal Mesh Coils,40-60W
- Center Spring-Loaded Ceramic Parts To Avoid Burnt Hits
- Wide Clamp Posts Building Deck Supports All Kinds of Coils
- Deep Juice Well
- Beehive Style Air Slots On Top Cap
- 810 Wide-Bore Resin Drip Tip
- Gold-Plated 510 Connection
1*Profile Mesh RDA
1*6MM Agleted Cotton Strip
1*810 Drip Tip
1*Mesh Style Coils
1*O-Rings & Screws
Note: please ensure you have basic knowledge on how to properly to use it.
1)If the tanks use sub-ohm coils, vapers must be sure that your device and batteries can handle sub-ohm coils, only recommend experienced users order this, extra safety precautions should be practiced when using a sub-ohm tank. the tank only works with the mod that can support the atomizer and coil. if you have a tank and resistance is 0.3ohm, you must sure that the mod or battery can support resistance low to 0.3ohm. improper use and lead to injury or damage. use the OHMS LAW Calculator to check. if you have a question, please feel free to contact us.
2) Smokstore will not responsible or liable for any injury, damage, defect, permanent or temporary that may be caused by the improper use of Li-ion battery, coils, tanks, mods. please have a basic knowledge of vape. Welcome to contact us anytime to get help.